The snake contains twelve segments motivated by servo motors and joined with metal brackets. The servos are controlled by an Arduino Mega and powered by a 7.4-volt battery pack. The snake can be controlled by an android app using Bluetooth. The snake is also capable of autonomous movement. Such a robot can be constructed with many different types of servos and brackets. Each of the 12 segments consists of a servo motor, a C-bracket, a side bracket, a wire clip and a set of Lego wheels. Two screw holes is to be drilled into the Lego wheel axle to permit it to be connected to the C-bracket. After all, 12 segments are connected, head and tail sections need to be added in order to accommodate the Arduino and batteries. To make them a side bracket and two long C-brackets connected. The Arduino and therefore the 5AA battery holder are used that powers it into the tail section of the snake. The servos are powered by a separate supply, the 7.4-volt battery pack, goes into the head of the snake. On the receiver, the bottom pin is connected to the Arduino ground. The voltage pin is connected to a 5-volt pin from the Arduino.

• Hardware Specifications

• Dual shaft Servo

• WIFI camera

• Analog distance sensor

• Arduino Mega2560

• Arduino Mega servo Shield

• Bluetooth Module

• Capacitors

• Cables and Connectors